ULiROBOTS TECHNOLOGY (SHANGHAI) CO., LTD.

Laser marking machine common problems

2021-04-13

Laser marking machine common problems

A.Computer common problems
 
1.The processing of the graphics is complex, must be checked.
 
2.Online computer do not connect to the network cable, it is a separate control of the laser system.
 
3.The operation is slow, please do not be too impatient at this time, so as not to crash.
 
4.Please pay attention to prevent virus, in case of system error.
 
B.The XY axis of the worktable is not on time
 
1. Whether the slide screw of the worktable is loose
 
2. The glass on the worktable can be set according to customer requirements. Iron plate or plexiglass plate can be replaced.
 
3, the right and upper and lower corners of the worktable can be installed electronic ruler, electronic ruler can be installed to facilitate the needs of customers.
 
4. The screw hole on the workbench can be convenient for customers to locate and use, which is denied by the product.
 
C.The operation of the jump, and the position is roughly fixed
 
The following several reasons and elimination methods:
 
1.The synchronous belt stretched too long deformation ----- replace a new synchronous belt.
 
2.The size of the gear reducer gear device pinion groove dirt ----- clean up the pinion groove dirt.
 
3. Drive shaft pinion has dirt ----- clean the dirt of drive shaft gear groove.
Previous:The reliability and durability of laser marking have brought
Next: Application of fiber laser marking machine in metal industry